Grizzly 1 1/2 HP Cyclone G0703 - Manual (Page 14)

-12-
Model G0703/G0703P (Mfg. Since 3/12)
Improper connection of the equipment-grounding
wire can result in a risk of electric shock. The
wire with green insulation (with or without yellow
stripes) is the equipment-grounding wire. If repair
or replacement of the power cord or plug is nec-
essary, do not connect the equipment-grounding
wire to a live (current carrying) terminal.
Check with a qualified electrician or service per-
sonnel if you do not understand these grounding
requirements, or if you are in doubt about whether
the tool is properly grounded. If you ever notice
that a cord or plug is damaged or worn, discon-
nect it from power, and immediately replace it with
a new one.
Extension Cords
We do not recommend using an extension cord
with this machine. If you must use an extension
cord, only use it if absolutely necessary and only
on a temporary basis.
Extension cords cause voltage drop, which may
damage electrical components and shorten motor
life. Voltage drop increases as the extension cord
size gets longer and the gauge size gets smaller
(higher gauge numbers indicate smaller sizes).
Any extension cord used with this machine must
contain a ground wire, match the required plug
and receptacle, and meet the following require-
ments:
Minimum Gauge Size ...........................12 AWG
Maximum Length (Shorter is Better).......50 ft.
Voltage Conversion
The Model G0703/G0703P can be converted
for 220V. This conversion requires installing a
220V plug, re-wiring the motor, and installing a
220V circuit board. The 220V circuit board, Part #
P0703P088, can be purchased by calling Grizzly
Customer Service at (800) 523-4777.
To convert the Model G0703/G0703P to 220V:
1. DISCONNECT MACHINE FROM POWER!
2. Remove the 110V plug from the power cord.
Figure 5. Remote receiver panel screws.
3. Remove the four screws that secure the
remote control receiver panel to the control
box (see
Figure 5).