Grizzly 1 1/2 HP Cyclone G0703 - Manual (Page 20)

-18-
Model g0703/g0703p (Mfg. Since 3/12)
assembly
to assemble the dust collector:
1. invert the stand, place a 3 ⁄
8
" lock washer on
each of the four caster wheel studs. then
thread each caster into the stand, and using a
3 ⁄
8
" wrench, tighten each caster stud onto the
stand (see figure 13).
figure 13. Stand and caster wheels.
2. rotate the stand to the upright position.
3. Secure the h-supports and upper stand rails
to the stand, as shown in figure 14, using
(16) 5 ⁄
16
"-18 x 3 ⁄
4
" hex bolts and (16) 5 ⁄
16
" flat
washers.
figure 14. installing stand rails.
h-Support
4. position the stand over the dust collector
housing, as shown in figure 15, and install
(1) 5 ⁄
16
"-18 x 1 1 ⁄
2
" hex bolt and flat washer on
each side of the stand to serve as pivot bolts
(leave bolts loose for now).
figure 15. pivot bolt installed.
pivot Bolt location on Both Sides
5. With the help of an assistant, carefully lay
the dust collector on its side, and line up the
stand with the remaining six mounting holes.
7. With the help of an assistant, lift the stand
and dust collector assembly upright into
place.
6. install the remaining (6) 5 ⁄
16
"-18 x 1 1 ⁄
2
" hex
bolts and (6) 5 ⁄
16
" flat washers, then tighten all
hex bolts (see figure 16).
figure 16. dust collector and stand positioning.
three Bolts
on
Both Sides
x 4
x 16
rail
Stand