Grizzly 1 1/2 HP Cyclone G0703 - Manual (Page 11)

Model g0703/g0703p (Mfg. Since 3/12)
-9-
intended use. this dust collector is only
intended for collecting wood dust and chips from
woodworking machines. do not use this dust
collector to collect metal, dirt, pebbles, drywall,
asbestos, lead paint, silica, liquids, aerosols, or
any flammable, combustible, or hazardous materi-
als.
hazardous dust. dust created while using
machinery may cause cancer, birth defects, or
long-term respiratory damage. Be aware of dust
hazards associated with each workpiece material,
and always wear a nioSh-approved respirator to
reduce your risk.
dust allergies. dust from certain woods
may cause an allergic reaction in people and ani-
mals. Make sure you know what type of wood dust
you will be exposed to in case there is a possibility
of an allergic reaction.
Wear respirator. Fine dust that is too
small to be caught in the filter will be blown into
the ambient air during operation. Always wear a
nioSh approved respirator during operation and
for a short time after to reduce your risk of perma-
nent respiratory damage.
emptying dust. When emptying dust from the
collection container, wear a respirator and safety
glasses. Empty dust away from ignition sources
and into an approved container.
disconnecting poWer supply. turn the
switch
OFF, disconnect the dust collector from
the power supply, and allow the impeller to come
to a complete stop before leaving the machine
unattended or doing any service, cleaning, main-
tenance, or adjustments.
regular cleaning. regularly check/empty
the collection bags or drum to avoid the buildup
of fine dust that can increase the risk of fire. Make
sure to regularly clean the surrounding area where
the machine is operated—excessive dust buildup
on overhead lights, heaters, electrical panels, or
other heat sources will increase the risk of fire.
suspended dust particles and ignition
sources. do not operate the dust collector in
areas were explosion risks are high. Areas of high
risk include, but are not limited to, areas near pilot
lights, open flames, or other ignition sources.
fire suppression. only operate the dust col-
lector in locations that contain a fire suppression
system or have a fire extinguisher nearby.
impeller hazards. do not place your
hands or tools near the open inlet during operation
for any reason. the powerful suction could easily
cause accidental contact with the impeller which
will cause serious personal injury or damage to
the machine. Always keep small animals and chil-
dren away from open dust collection inlets.
avoiding sparKs. do not allow steel or
rocks to strike the impeller—this may produce
sparks. Sparks can smolder in wood dust for a
long time before a fire is detected. if you acciden-
tally cut into wood containing tramp metal (nails,
staples, spikes, etc.), immediately turn
OFF the
dust collector, disconnect it from power, and wait
for the impeller to stop—then empty the collec-
tion container into an approved airtight metal
container.
operating location. to reduce respira-
tory exposure to fine dust, locate permanently
installed dust collectors away from the working
area, or in another room that is equipped with a
smoke detector. do not operate the dust collec-
tor in rainy or wet locations—exposure to water
may create an shock hazard or decrease the life
of the machine.
static electricity. plastic dust lines gener-
ate high amounts of static electricity as dust chips
pass through them. Although rare, sparks caused
by static electricity can cause explosions or fire.
to reduce this risk, make sure all dust lines are
thoroughly grounded by using a grounding wire.
additional safety for dust collectors