GoVideo D640 - Manual (Page 24)

24
Disc Handling & Maintenance
Handling Precautions
• Hold the disc by the edges so
the surface will not be soiled
with fi ngerprints.
• Fingerprints, dirt and scratches
can cause skipping and
distortion.
• Do not write on the label side
with a ball-point pen or other
writing utensil.
• Do not use record cleaning
sprays, benzine, thinner, static
electricity prevention liquids, or
any other solvent.
• Be careful not to drop or bend
the disc.
• Do not install more than one
disc on the disc tray.
• Do not try to close the disc tray
when the disc is not installed
properly.
• Be sure to store the disc in its
original case when not in use.
If the surface is soiled
• Wipe gently with a soft, damp (water only) cloth.
• When wiping discs, always move the cloth from the
center hole toward the outer edge. (If you wipe the
disc using a circular motion, circular scratches are
likely to occur, which will cause noise.)
If the disc is brought from a cold to a warm
environment, moisture may form on the disc
• Wipe moisture off with a soft, dry, lint-free cloth
before using the disc.
Improper disc storage
You can damage discs if you store them in the
following places:
• Areas exposed to direct sunlight
• Humid or dusty areas
• Areas directly exposed to a heat outlet or heating
appliance
Disc which cannot be played with this player
• CD-ROM (Application Program)
• CVD
• DVD with a Region Code other than that shown
on the DVD unit’s Region Code Label on the rear
panel
Maintenance
• Be sure to turn the unit off and disconnect the AC
power cord before maintenancing the unit.
• Wipe this unit with a dry soft cloth. If the surfaces
are extremely dirty, wipe clean with a cloth which
has been dipped in a weak soap-and-water
solution and wrung out thoroughly, and then wipe
again with a dry cloth.
• Never use alcohol, benzine, thinner, cleaning fl uid
or other chemicals. And do not use compressed air
to remove dust.
5 - Help (cont.)
Power cord protection
To avoid any malfunctions of the unit, and to protect
against electric shock, fi re or personal injury, please
observe the following:
• Hold the plug fi rmly when connecting or
disconnecting the AC power cord.
• Keep the AC power cord away from heating
appliances.
• Never put any heavy object on the AC power cord.
• Do not attempt to repair or reconstruct the AC
power cord in any way.
Placement
Avoid placing the unit in areas of:
• direct sunlight or heating radiators, or closed
automobiles
• high temperature (over 95°F) or high humidity
(over 90%)
• signifi cant dust as the internal parts may be
seriously damaged.
Non-use periods
When the unit is not being used, turn it off. When left
unused for a long period of time, the unit should be
unplugged from the household AC outlet.
No fi ngers or other objects inside
• Touching internal parts of this unit is dangerous,
and may cause serious damage to the unit. Do not
attempt to disassemble the unit.
• Do not put any foreign object in the disc tray.
Keep away from water
• Keep the unit away from fl ower vases, tubs, sinks,
etc. If liquids are spilled into the unit, serious
damage could occur.
Keep away from magnets
Never bring a magnet or magnetized object near the
unit.
Stacking
• Place the unit in a horizontal position, and do not
place anything heavy on it.
Condensation
Moisture may form on the lens in the following
conditions:
• immediately after a heater has been turned on
• in a steamy or very humid room
• when the unit is suddenly moved from a cold
environment to a warm one
If moisture forms inside this unit, it may not operate
properly. In this case, turn on the power and wait
about one hour for the moisture to evaporate.
If there is noise interference on the TV while a
broadcast is being received
Depending on the reception condition of the TV,
interference may appear on the TV monitor while you
watch a TV broadcast and the unit is left on. This is
not a malfunction of the unit or the TV. To watch a TV
broadcast, turn off the unit.