GoVideo D640 - Manual (Page 20)

20
4 - Settings (cont.)
Audio Setup
Audio Out
The digital audio output jacks (labeled
“Coaxial” and “Optical”) are used to output
the audio signal recorded on DVD discs to
an external digital amplifi er/receiver. Use the
Audio Out setting to specify the format of the
digital signal from these jacks.
1 Press SETUP.
2 Press 22  /  to
select “AUDIO
SETUP” .
3 Press 33  /  to
select “AUDIO
OUT”, then
press  .
4 Press 44  /  to select your preferred Digital
Out setting.
• SPDIF/OFF - Select if you are not using
the digital audio output.
• SPDIF/RAW - Select if the player is
connected to a 5.1 channel amplifi er/
receiver with a Dolby Digital decoder.
• SPDIF/PCM - Select if the player
is connected to a 2 channel digital
amplifi er.
5 Press 55 ENTER.
6 Press SETUP or select “EXIT SETUP” to
exit the menu system.
WARNING:
• Do not set “AUDIO OUT” to “SPDIF/
RAW” unless you are connecting the
player to an amplifi er/receiver with Dolby
Digital (AC-3) decoding capability.
• High volume sound may damage your
hearing as well as the speakers.
Digital Setup
Dynamic Range
You can compress the dynamic range (the
difference between the quietest and loudest
passages) of a DVD soundtrack.
1 Press SETUP.
2 Press 22
 /  to
select “DIGITAL
SETUP” .
3 Press 33  /  to
select “DYNAMIC
RANGE”, then
press  .
4 Press 44  /  to adjust the Dynamic Range in
1/8 increments from OFF (no compression)
to FULL (maximum compression).
5 Press 55 ENTER.
6 Press SETUP or select “EXIT SETUP” to
exit the menu system.
Dual Mono
You can specify the format of the audio signal
from the left/right Audio Out jacks.
1 Press SETUP.
2 Press 22  /  to
select “DIGITAL
SETUP” .
3 Press 33  /  to
select “DUAL
MONO”, then
press  .
4 Press 44  /  to
select STEREO (separate left and right
channels), MONO L (left channel only),
MONO R (right channel only), or MIX
MONO (mixed left and right channels).
5 Press 55 ENTER.
6 Press SETUP or select “EXIT SETUP” to
exit the menu system.