Gateway DVD Player - Manual (Page 47)

41 www.gateway.com
12
On the player, highlight OK , then press ENTER on the remote control. Network setup
is complete.
13
Press SETUP to close the Welcome to Setup screen.
14
Go to “Customizing” on page 45 for instructions on customizing your player’s other
settings.
Wired Ethernet setup
To configure the player for a wired Ethernet network:
1
Make sure that your computer is on and Media Server is running. The Media Server
icon
in the Windows taskbar shows that the program is running.
If the Media Server icon has a red “x” on it, Media Server is running but cannot
connect to the network. See
“Network troubleshooting” on page 83 .
2
On the player’s remote control, press STOP , then press SETUP . The Welcome to Setup
screen opens on the TV.
3
Use your remote control’s arrow buttons to highlight Network , then press ENTER . The
message “Loading network settings” appears, and the player automatically connects
to the wired Ethernet network. If multiple networks are available, highlight the
Network setting, then press ENTER again to select the correct network from the list.
The IP address appears in the lower-right corner of the screen. To change the way the
IP address is selected, see
“Setting the IP address” on page 42 . To change the player
name (as it appears to other players), see “Changing the player name” on page 43 .
4
Highlight OK , then press ENTER . Network setup is complete.
5
Press SETUP to close the Welcome to Setup screen.
6
Go to “Customizing” on page 45 for instructions on customizing your player’s other
settings.