Gateway DVD Player - Manual (Page 45)

39 www.gateway.com
If you selected ASCII characters in Step 8 , enter the key according to the table below:
12
Highlight OK , then press ENTER .
13
Highlight OK again, then press ENTER . Network setup is complete.
14
Press SETUP to close the Welcome to Setup screen.
15
Go to “Customizing” on page 45 for instructions on customizing your player’s other
settings.
Wireless peer-to-peer setup
To configure the player for a wireless peer-to-peer network:
1
Make sure that your computer is on and Media Server is running. The Media Server
icon
in the Windows taskbar shows that the program is running.
If the Media Server icon has a red “x” on it, Media Server is running but cannot
connect to the network. See
“Network troubleshooting” on page 83 .
2
On the player’s remote control, press STOP , then press SETUP . The Welcome to Setup
screen opens on the TV.
Press: For:
1 1 . @ / : ‘ , ? ! - _ # * \ " $ % & + ; = ( ) < > [ ] ‘ ~ ^ { } |
2 2, A, B, C, a, b, c
3 3, D, E, F, d, e, f
4 4, G, H, I, g, h, i
5 5, J, K, L, j, k, l
6 6, M, N, O, m, n, o
7 7, P, Q, R, S, p, q, r, s
8 8, T, U, V, t, u, v
9 9, W, X, Y, Z, w, x, y, z
0 0
Important Wireless network cards used in a peer-to-peer network must be set
to
ad hoc mode instead of infrastructure mode. For more information
on how to do this, see your network card’s documentation.