Changing speeds – Grizzly G1095/G1096 User Manual
Page 23

Model g1095/g1096 1-hp power Feeder
-21-
Figure 14. Change gear locations.
Change gear position
b
Change gear
position
a
Figure 13. Feed direction and speed dial.
your power feeder has the option to feed a
workpiece at 13, 26, 33, and 66 feet per minute.
these rates are achieved by changing the combi-
nation of change gears, and by turning the motor
switch to high or low range operation.
to change the feed rate of your power
feeder:
1. disConneCt the poWer Feeder
FroM poWer!
2. Make sure the speed dial is pointing to "0"
(the
OFF position, Figure 13).
changing Speeds
always disconnect power
to the machine before
performing installation
or maintenance. Failure
to do this may result in
serious personal injury.
26 Ft Per Min: a, 40 tooth + b, 25
tooth.
33 Ft Per Min: a, 25 tooth + b, 40
tooth.
66 Ft Per Min: a, 40 tooth + b, 25
tooth.
Motor OFF.
13 Ft Per Min: a, 25 tooth + b,
40 tooth.
3. refer to the feed rate list below to find the
gear combination required for your chosen
feed rate.
4. remove the chain cover and the two hex
nuts securing the
a & b change gears to the
shafts shown in
Figure 14.
5. swap the required change gears so the gear
hubs are facing in toward the power feeder
(shown in positions
a & b in Figure 14).
6. reinstall the hex nuts and chain cover.
7. Connect the power feeder to power and
move the feed direction and speed dial to the
high or low range.