Stovax PR0919 - Manual (Page 25)

3.2 To completely remove the glass front:
• Remove the securing spring clip from the bottom-right of
the window frame, Diagram 3
3
AR1862
3.3 With the window frame in an upright position:
• Slide the frame to the left so that it comes off the left
hinge pin
Still keeping the frame upright:
• Drop the left side down and forward slightly, Diagram 4
4
AR1863
• Slide the frame to the right so that the frame comes off
the right hinge pin. The window frame is now free.
• Refit in reverse order
1. GENERAL
1.1 All main components can be replaced without removing the
appliance from its installation. i
T is EssENTial ThaT ThE gas
supply TO ThE appliaNcE is TurNEd Off aT ThE isOlaTiON dEvicE
bEfOrE prOcEEdiNg furThEr .
1.2 Removal of Flue
If, for any reason, the flue has to be removed from the
appliance, the seal must be replaced in the inner spigot.
1.3 Access to the controls is restricted and the whole of the
control assembly is to be removed as one unit. Refer to
Section 7 below
2. DECORATIVE FRAME
2.1 The same method is used to remove each frame.
• Lift the frame upwards off the four support brackets,
Diagram 1
1
NOTE: THE STEEL FRAME IS HEAVY. TAkE CARE WHEN
LIFTING
3. WINDOW FRAME ASSEMBLY
3.1 To open the glass door, use the allen key provided:
• Release the two window locks
The lock needs to be moved from shut to open towards the
outer edges, Diagram 2
2
AR1860
25
SERVICING INSTRUCTIONS
REPLACING PARTS