Stovax PR0919 - Manual (Page 14)

14
INSTALLATION INSTRUCTIONS
SITE REQUIREMENTS/INSTALLATION
5. APPLIANCE LOCATION
5.1 Please note this appliance has been specifically designed for
stud work applications. There are two methods of
installation, see Installation Instructions 3.2 Frame, 3.3
Edge
5.2 This appliance must stand on a non-combustible hearth/
platform that is at least 12mm thick.
NOTE: It is recommended you construct the back panel
of the fireplace from natural materials cut into three or
more sections to prevent cracking. Resin-based materials
may not be suitable. This appliance is an effective heat
producer and attention must be paid to the construction
and finish of the fireplace.
5.3 A combustible shelf must be:
• maximum 150mm in depth
• minimum, 400mm high above the fire
A combustible side wall must be a minimum of 150mm
from the appliance.
5.3 This appliance can be installed with an up and out flue
(vertical wall - horizontal flue) or with a vertical flue with
roof termination (see flue options, Section 2 Site
Requirements).
IMPORTANT: REFER TO DATA BADGE AND TECHNICAL
SPECIFICATION AT THE FRONT OF THE MANUAL TO
ENSURE THE APPLIANCE IS CORRECTLY ADJUSTED FOR
THE GAS TYPE AND CATEGORY APPLIED IN THE
COUNTRY OF USE.
FOR DETAILS OF CHANGING BETWEEN GAS TYPES
REFER TO SECTION 10, SERVICING, ‘REPLACING PARTS’.
1. SAFETY PRECAUTIONS
1.1 For your own and other’s safety, you must install this stove
according to local and national codes of practice. Failure to
install the stove correctly could lead to prosecution:
• Read these instructions before installing and using this
stove.
1.2 These instructions must be left intact with the user.
1.3 Do not attempt to burn rubbish on this appliance.
1.4 Keep all plastic bags away from young children.
1.5 Do not place any object on or near to the appliance and
allow adequate clearance above the appliance.
IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN
USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO
RELIGHT THE APPLIANCE.
2. INSTALLATION OF THE APPLIANCE
THERE IS AN OPTIONAL DUCT KIT, CODE No. 8572
WHICH CAN BE FITTED AT THE SAME TIME AS THE
APPLIANCE INSTALLATION.
2.1 Remove the appliance from the carton and discard all
unnecessary packaging. Ensure no components are thrown
away when unpacking.
2.2 To open the glass door, use the allen key provided:
• Release the two window locks
The lock needs to be moved from shut to open towards the
outer edge of the glass door, Diagram 1
1
AR1860
2.3 The gas supply enters the fire through a silicon panel on the
floor under the access panel, Diagram 2:
• Slit with a sharp knife before bringing through the supply
pipe, Diagram 3