Stovax PR0919 - Manual (Page 16)

16
INSTALLATION INSTRUCTIONS
INSTALLATION
• Fit the supplied top support bar into the stud work at the
correct height, Diagram 7, because no combustible material
can be used above the fire
7
AR1904
• Attach the 4 frame fixing brackets to the fire, Diagram 8
• Fix foam seal to the outer flange of the fire
8
AR1913
• Position the fire
• Fit non-combustible board to the stud work around the
fire. This should extend a minimum of 400mm above the
appliance and at least 50mm to the sides of the appliance
(from the outer box, not the flanges).
• Apply plasterboard to the remainder of the stud work
• Secure the fire back to the stud work using four screws
through flange, bracket, support bar
• Apply a plaster finish to the front of the chimney breast
• Decide on the position for the wall box containing the
batteries and wall switch
• Connect the wire from the fire to the battery pack,
Diagram 9
9
AR1920
• Connect the wire from the fire to the touch pad/
connector, Diagram 10
10
AR1919
• Correctly position the four new AA size batteries
• Re-assemble the battery holder as shown in Diagram 11
• Ensure the touch pad cable is tucked to the left on fitting
the wall plate back onto the wall
11
AR1932
• Secure the wall plate with the touch pad attached to the
wall box, Diagram 12
12
AR1887
wall plate
Because of the high temperatures this fire achieves, it is
advisable to use marble slips or similar material between the
appliance and the plasterboard
Never use a one-piece slip as expansion (even cracking)
can occur. If a slip is used, longer screws are needed to
secure the appliance.
• Connect the flue system and gas services using the
opening in the side of the chimney breast for access. After
commissioning, finish the sides of the chimney breast,
Diagram 13