Installation instructions, Installation, Lighting the studio – Stovax PR0919 User Manual

Page 20

INSTALLATION INSTRUCTIONS

INSTALLATION

• Offer the frame to the foot of the opening

• Slide the frame to the right to locate the right hinge pin

AR1865

5.4 • Manoeuvre the frame up towards the left side to locate

the left hinge pin

• Slide onto the hinge with a right movement

• Secure in place with a spring clip at the right hinge pin,

Diagram 25

AR1862

• Close the window

5.5 Using the allen key provided:

• Close the window locks by moving from open to shut

towards the window centre

AR1860

6. LIGHTING THE STUDIO

Note: The Emergency Shut Off switch must be in the ON

position, refer to Section 2, User Instructions.

There are two ways of lighting the Studio:

• by thermostatic remote control

• using the fire’s touch pad

THERMOSTATIC REMOTE CONTROL

AR1883

This remote controls the appliance from pilot ignition

through to shut down. In ‘MANUAL MODE’ you can:

• light the pilot

• turn on the main burner

• regulate the flame from low to high and back

• turn off the burner leaving just the pilot burning

In ‘TEMP MODE’ you can:

• set the room temperature so the stove automatically

maintains that temperature

In ‘TIMER MODE’ the stove:

• turns on and off according to the set time periods

• automatically regulates the room temperature during the

set periods

TOUCH PAD CONTROL

AR1885