Test run – Grizzly G0636X User Manual

Page 22

-20-

G0636X 17" Ultimate Bandsaw

5. Press the OFF button to stop the machine.

6. WITHOUT resetting the OFF button, press

the ON button. The machine should not
start.

—If the machine does not start, the OFF but-

ton safety feature is working correctly.

—If the machine does start (with the stop

button pushed in), immediately disconnect
power to the machine. The OFF button
safety feature is not working correctly. This
safety feature must work properly before
proceeding with regular operations. Call
Tech Support for help.

7. Push the OFF button in, then twist it clock-

wise so it pops out. When the OFF button
pops out, the switch is reset and ready for
operation (see

Figure 21).

Test Run

Once the assembly is complete, test run your
machine to make sure it runs properly and is
ready for regular operation.

The test run consists of verifying the following: 1)
The motor powers up and runs correctly, 2) the
safety disabling mechanism on the switch works
correctly, and 3) the stop button safety feature
works correctly.

If, during the test run, you cannot easily locate
the source of an unusual noise or vibration,
stop using the machine immediately, then review

Troubleshooting on Page 42.

If you still cannot remedy a problem, contact our
Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1. Make sure you have read the safety instruc-

tions at the beginning of the manual and that
the machine is setup properly.

2. Make sure all tools and objects used during

setup are cleared away from the machine.

3. Connect the machine to the power source.

4. Verify that the machine is operating correctly

by turning the switch disabling key (

Figure

20) to "1" and turning the machine ON.

—When operating correctly, the machine

runs smoothly with little or no vibration or
rubbing noises.

— Investigate and correct strange or unusual

noises or vibrations before operating the
machine further. Always disconnect the
machine from power when investigating or
correcting potential problems.

��

��

��
��

Figure 21. Resetting the switch.

Figure 20. G0636X switch disabling key and

ON/OFF switch.

8. Turn the switch disabling key to "0", as shown

Figure 20.