First Alert FA1220CV - Manual (Page 34)

– 34 –
USING #70 RELAY MENU MODE
General
Information
NOTE: Using #70 Menu
Mode requires an alpha
keypad.
Your system may be set up so that certain lights or other devices can be turned on or off by
using the #70 command from either a keypad or a telephone keypad (if phone module is used).
Ask your installer if this has been done in your system.
To activate relays from a keypad, enter 4-digit security code + [#] + [7] [0]. Follow the keypad
prompts described below.
To activate relays using the telephone (if phone module is used), first dial the 2-digit phone
access code. When the system acknowledges the access, enter the 4-digit security code + [#] +
[7] [0]. The following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT 01 Voice: "ENTER DEVICE CODE NOW"
Enter the 2-digit number of the device to be activated.
Note that if an invalid number is entered, the system will simply ask
you to reenter the number.
NN DEVICE IS OFF
HIT 0=OFF , 1=ON
Voice: " voice descriptor DEVICE nn ON/OFF. FOR voice descriptor ON
ENTER 1, FOR voice descriptor OFF ENTER 0"
Press 0 or 1 to turn the device off or on respectively.
"nn" represents the 2-digit device number and
voice descriptor is the
relay voice descriptor programmed by the installer.
NN DEVICE IS OFF
HIT THE "*" KEY
Voice: " voice descriptor DEVICE nn ON/OFF. TO EXIT ENTER 00 NOW"
From a keypad, press [ ✽ ] to continue. The ENTER DEVICE NO.
prompt will appear.
From a telephone keypad, enter 00 to exit, or enter the next relay
number to be programmed. The current on/off state of that relay will
be annunciated as described above. Alternatively, if 6 seconds
elapses with no key depression, the voice module will annunciate the
"ENTER DEVICE CODE NOW" message.
Technical Manuals Online! - http://www.tech-man.com