First Alert FA1220CV - Manual (Page 29)

– 29 –
SECURITY CODES & AUTHORITY LEVELS
To Add a User
NOTE: Adding/deleting
security codes can only
be done from an alpha
keypad.
IMPORTANT: Temporary users should not be shown how to use any system function they do
not need to know (e.g. bypassing protection zones).
CODE
1. Enter Master or Manager code and press the 8 key.
2. Enter the new user's 2-digit User Number (02–69).
3. Enter 4-digit security code for that user. The following prompts will appear.
ADD NEW USER?
0 = NO , 1 = YES
Enter 1 to add a new user code. Entering 0 will change the existing
user's code to the code entered in step 3. See
Changing A User's
Code section.
† Refer to the #84
Command section for
setting usage counter
for limited use users.
USER NUMBER = 3
ENTER AUTH.LEVEL
Enter the authority level, 1–6, for this user within this partition.
1=master 3=operator A 5=operator C 7=Limited Use†
2=manager 4=operator B 6=duress code
RF BUTTON ?
0 = NO , 1 = YES
This prompt will appear if a 5800 series button transmitter has
been supplied and has not yet been assigned to a user.
Press 1 if a button transmitter will be assigned to this user.
Otherwise press 0 .
ENTER BUTTON ZN #
(01-64)
If assigning a button transmitter, this prompt will appear. Enter the
button's zone number (see your installer for zone number).
MULTI-ACCESS ?
0 = NO , 1 = YES
If you as a user have access to other partitions, the keypad will
prompt for ability of this new user to access (GOTO) those
partitions. Press 0 (NO) or 1 (YES). If no, the system activates this
user code and exits “Add a User” mode. If yes, the keypad prompts
for the Global Arm option for this user.
Technical Manuals Online! - http://www.tech-man.com