First Alert FA1220CV - Manual (Page 15)

– 15 –
BYPASSING PROTECTION ZONES
Using the 6
BYPASS Key
This key is used when you want to arm your system with one or more zones intentionally
unprotected. Bypassed zones are unprotected and will not cause an alarm when violated while
your system is armed. All bypasses are removed when an OFF sequence (security code plus
OFF) is performed. Bypasses are also removed if the arming procedure that follows the bypass
command is not successful.
Note: The system will not allow fire or emergency zones (keypad panics A, B, C) to be
bypassed.
To bypass zones, the system must be disarmed first.
(Your system may include special high security zones. If so, these zones can be bypassed
while the system is armed or disarmed. Ask your installer if your system has these zones.)
BYPASS
1. Enter your security code and press 6 .
2. Enter zone number(s) for the zones to be bypassed (e.g., 01, 02, 03, etc.).
Important! All single-digit numbers must be preceded by a zero (for example, enter 01 for
zone 1).
3. BYPASS 07 FRONT
UPSTAIRS BEDROOM
Typical bypass message
When finished, the keypad will display the word BYPASS along
with each bypassed zone number. Wait for these zones to be
displayed before arming. Arming the system before bypassed
zones are displayed eliminates all bypasses.
4. DISARMED BYPASS
READY TO ARM
Arm the system as usual when the keypad displays "ready" to arm
message.
Technical Manuals Online! - http://www.tech-man.com