Furuno GP-150-DUAL - Manual (Page 49)

7. ALARMS
7-3
7.4 Speed Alarm
The speed alarm sounds when ship's speed
is lower or higher (or within) the alarm range
set.
1) Press
MENU ESC and 4.
2) Press or to select Ship Speed.
3) Press or to select In or Over.
In: Alarm sounds when speed is within range
set.
Over: Alarm sounds when speed is higher or
lower than range set.
4) Press to select Speed Range.
5) Key in low speed.
6) Key in high speed.
7) Press the
NU/CU ENT key.
8) Press the MENU ESC key.
When speed is higher or lower (or within)
than the speed set here, the buzzer sounds
and the message "Speed alarm" appears.
7.5 Trip Alarm
The trip alarm sounds when the distance run
is greater than the trip alarm setting.
1) Press
MENU ESC and 4.
2) Press to select Next Page. The menu
shown in Figure 7-6 appears.
ALARM SETTINGS 2/2
To Previous Page
On Off
Trip Range 0123.00nm
Water Temp. In Over Off
Temp. Range +12.0 ~ +15.0
°C
Depth In Over Off
Depth Range 0003.0 ~ 0200.0ft
WAAS/DGPS On
Trip (CLR:Reset) Off
Off
MENU : Escape
: Select ENT : Enter
: +/-
Figure 7-6 Alarm settings menu, page 2/2
3) Press or to select Trip.
4) If necessary, press
CLEAR to reset the
trip distance and trip elapsed time.
5) Press or to select On.
6) Press to select Trip Range.
7) Key in trip range.
8) Press the
NU/CU ENT key.
9) Press the MENU ESC key.
When the ship's distance run is higher than
the trip range set here, the buzzer sounds
and the message "Trip alarm" appears.