Furuno GP-33 User Manual
Page 79
9. INSTALLATION
9-11
Output setting
1. Press the MENU/ZOOM key twice to show the main menu.
2. Select [I/O Setup], then press the ENT key.
3. Select [Data 2], [Data 3] or [NMEA0183 Version] depending on the equipment
connected.
4. Press the ENT key. One of the following screens appears depending on the item
selected at step 3.
5. Press S or T to select the option.
REM1, 2: Output data to radar, echo sounder.
AP: Output data to an autopilot.
GPS: Output GPS data (used for the service)
2.0, 3.0: select the NMEA version of external equipment. If you are unsure of the
version number, try both and select the one which successfully outputs data.
6. Press the ENT key.
7. Press the MENU/ZOOM key twice to close the menu.
㵰㪛㪸㫋㪸㪉㪆㪛㪸㫋㪸㪊㵱 㵰㪥㪤㪜㪘㪇㪈㪏㪊㩷㪭㪼㫉㫊㫀㫆㫅㵱
See also other documents in the category Furuno GPS receiver:
- MARINE RADAR 1953C (100 pages)
- GP-1650D (2 pages)
- GP-1650WD (96 pages)
- GP-1650W (96 pages)
- NAVNET 1943C-BB (92 pages)
- GD-3300 (137 pages)
- DUAL GPS GP-150-DUAL (130 pages)
- GP-1650WF (113 pages)
- CH-300 (124 pages)
- NX-300 (65 pages)
- NX-300 (2 pages)
- GP-1850WDF (115 pages)
- GP-3500 (192 pages)
- GP-1850WD (44 pages)
- GP-1850W (98 pages)
- GP-1850WD (98 pages)
- GP-1850W (4 pages)
- GP-1850W (98 pages)
- INTERFACE UNIT IF-2500 (12 pages)
- GP-31 (2 pages)
- GP-7000 (28 pages)
- GP-7000 (2 pages)
- GP37 (2 pages)
- GP-90 (36 pages)
- CI-35 (69 pages)
- GP-1850DF (63 pages)
- GP-1850F (110 pages)
- GP-30 (2 pages)
- FCV-30 (110 pages)
- BACK GP-80 (103 pages)
- LC-90 MARK-II (2 pages)
- GP-1650W (44 pages)
- DD-80 (119 pages)
- RP-250 (73 pages)
- GP-1650 (94 pages)
- GP-185F (4 pages)
- GP-1600F (97 pages)
- GP-1850D (94 pages)
- GP-7000F (132 pages)
- GP-7000F (52 pages)
- GP-36 (81 pages)
- GP-150-DUAL (123 pages)
- GP-80 (37 pages)
- 1650WDF (4 pages)