Red-line, Contour, Attack – Fortinet 2 SXRC User Manual

Page 79

Operating Voltage:

Remote Turn-On Voltage:

Internal Fusing in SXRC
Interface Box:

Maximum Amplifiers:

Maximum Groups:

DRVC Range:

Power, Ground, Remote
Terminals:

Mounting Hardware:

9-16 volts DC

Mini Glass Fast Blow 3 amp

16 units

10 groups

30 dB

Removable plug will accept
up to 12 gauge wire.

Standard DIN 7-3/16 x 2-1/8

182mm x 53mm

SXRC Remote Control

Specifica

tions

A few words on the Kompressor™. The effect is most

noticeable in the bass area of your music (Bass/Midbass). You
can use the Kompressor™ in any amplifier configuration
(Low Pass, High Pass, Band Pass or Full Range) but we feel the
most dramatic results are obtained when the amp is in a Low
Pass (subwoofer) or Band Pass (midbass) situation.

A few exceptions to this statement are:

The

red-line

setting is good for use in any configuration

as it helps control dynamic peaks and limit distortion at
higher output levels. VERY effective at controlling speaker
damaging distortion caused by over-driving or clipping the
amplifier.

The

contour

setting is also another good all around use

setting and when used in Full Range or High Pass
configurations tends to enhance the vocal and top end of
the music. Great for helping to cover up interior noise.

The

ATTACK

setting is really geared for bass and midbass

duty but can be used in any setup.

Remember, these are just suggestions, play around with each

Kompressor™ preset and the Threshold (KOMP ADJ) to find
what works for you.

The possibilities are almost endless! Tweak away!

SXRC Specifications

HOME

ENT

ESC

SYS

MEM-1

GAIN

LPF

HPF

KOMP

AMP1

LOCK

MEM-2

MEM-3

MEM-4

PHASE

MUTE

AMP2

LEFT

RIGHT

k e