Fortinet 2 SXRC - Manual (Page 71)

71
SXRC Remote Control
Opera
tion
SAVE ALL MENU - Here you can download the current SXRC
settings for each amplifier into any one of the four SX Series
amplifiers on-board memories. (
Mem-1 through Mem-4 )
This is useful for several purposes.
1.) You could have a preferred setup programmed into the
SXRC and then simply plug it into the system and download all
the settings into the amplifiers. Then un-plug the SXRC and the
settings are now loaded into one of the amplifier’s memory
presets for use. Talk about a one-touch programming tool!
2.) You may want to disconnect your SXRC from the system
and take it with you. By saving all the current settings in the
SXRC to the amplifiers the system will operate without the SXRC
but with the exact settings you were using.
3.) The 3-step-plan to sanity: Save, Save and Save. By
saving your current settings from the SXRC into your amplifiers
you have a backup of all your programming. If something should
ever happen to your SXRC (Beverage spill, Sat on and crushed,
girlfriend throws out the window at 60 MPH) you will have all your
hard-earned system programming backed-up in your
amplifiers. You could then follow the 3-step-plan to happiness:
Remember, Remember, Remember. Simply plug in a new (or
repaired) SXRC, perform an Autosearch, save the settings back
into a global SXRC memory and your back in business.
Ain’t technology just swell!
Once you are in the SAVE ALL menu you
need to decide if you want to download
the current settings in the SXRC or any
one of the four SXRC global memories.
If you want to download the current settings in use, skip the
steps marked with a
*
* Press any one of the four SXRC global
memory presets to load it into the SXRC.
* The display will show LOADING while
the global memory preset loads and then
the display will show which preset is
loaded and active.
Press the ENT key to enter the SAVE ALL
memory location selection menu.
Use the UP or DOWN keys to scroll
through the available memories ( mem-1
through mem-4 ). This will be the memory
preset the SXRC uses on each amplifier to
store your settings.
When you have the memory selected that
you want to use simply press the
ENT key
to select it.
The settings will be saved to the SX
Series amplifiers and the display will
return to
SAVE ALL . You are now back in
the SXRC SETUP menu.
HOME ENT ESC
HOME ENT ESC
s s a v v e e a a l l l l
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT RIGHT
M1 M2 M3 M4
l l o a a d d i i n n g g
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT RIGHT
HOME ENT ESC
s s a v v e e a a l l l l
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT RIGHT