Fortinet 2 SXRC - Manual (Page 77)

RECALLING A PRESET
To recall a memory preset simply press and
release the desired memory key. The matching
indicator in the ISIS display will light up and
the SXRC will display
LOADING while it
loads all the settings stored in that preset
into each SX Series amplifier.
There are four global memory presets built into the SXRC,
each with its own indicator in the ISIS display and a dedicated
memory key to activate it.
Each memory preset stores all the values
shown at the right for each amplifier connected
to the SXRC.
This gives you the ability to dial in four
completely different system settings and store
them in the memory presets for instant recall at
any time.
STORING A PRESET
To store the current amplifier or group
settings in the SXRC into a memory preset
simply press and hold the desired memory
key until the ISIS display flashes
STORED and
then release the memory key.
77
SXRC Remote Control
Opera
tion
Memory Presets
» GAIN
» EQ
» LO-PASS
» HI-PASS
» PHASE
» MUTE
» KOMPRESSOR
» KOMP. ADJ.
» REMOTE VOL
s s t t o o r r e e d d
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT RIGHT
HOME ENT ESC
M1 M1 M2 M2 M3 M3 M4 M4
SYS SYS
MEM-1 MEM-1
GAIN GAIN EQ EQ LPF LPF HPF HPF KOMP KOMP
AMP1 AMP1
LOCK LOCK
MEM-2 MEM-2 MEM-3 MEM-3 MEM-4 MEM-4
PHASE PHASE
MUTE MUTE
AMP2 AMP2
LEFT LEFT RIGHT RIGHT
* * * * k k i i c c k k e e r r
M1 M2 M3 M4
PRESS &
HOLD
M1 M2 M3 M4
L L O A A D D I I N N G G
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1
LOCK
MEM-2 MEM-3 MEM-4
PHASE
MUTE
AMP2
LEFT RIGHT