Fortinet 2 SXRC - Manual (Page 12)

12
SXRC Remote Control
Installa
tion
Using the R-Tool
The included R-Tools are used to remove the SXRC Control
Head from the Trim Ring/Metal Cage assembly. The R-Tools
simply slide into the notched area on both sides of the Plastic
Cosmetic Trim Ring and will release the clips holding the SXRC
Control Head.
M1 M2 M3 M4
HOME ENT ESC
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1 LOCK
MEM-2 MEM-3 MEM-4
PHASE MUTE AMP2 LEFT RIGHT
* * k i c k e r
R-Tool R-Tool
Wiring
Now that you have mounted your SXRC Control Head it is time
to do some wiring. The first step is to plug your SXRC Control
Head into the SXRC Interface Box.
Next, run a fused (5 amp) constant 12 volt, ground and remote
turn on to the SXRC Interface Box. Connect the wiring to the
removable power plug by loosening the set screws, inserting the
stripped wire and then tightening the set screw.
M1 M2 M3 M4
HOME ENT ESC
SYS
MEM-1
GAIN EQ LPF HPF KOMP
AMP1 LOCK
MEM-2 MEM-3 MEM-4
PHASE MUTE AMP2 LEFT RIGHT
* * k i c k e r
FROM AMP + 12V REM GND
TO SXRC
Interface Box
Control Head
Power On
LED
PS2 - SXRC
Connector
HyperFlex
HyperFlex
HyperFlex
Strip Back Wire
1/4" (6 mm)
Ground
Remote
+ 12 Volt
Tighten Set Screw Loosen Set Screw
5
Fuse