Fortinet 2 SXRC - Manual (Page 10)

10
SXRC Remote Control
Installa
tion
Surface Mounting With Screws
The SXRC Control Head can also be surface mounted if you
do not have a spare DIN opening in your dash or do not want to
cut one into an existing panel.
The back of the SXRC Control Head has two metal inserts
designed to work with M3 screws.
Find a suitable location and drill two 1/8 inch (3 mm) holes to
secure the SXRC Control Head.The holes should be 5-17/32”
(140 mm) apart from center to center.
NOTE: You will need to have access to the area behind this
location to install the mounting screws.
Inserts for M3 Screws
Center to Center
5-17/32" (140mm)
Mounting Surface
Center to Center
5-17/32" (140mm)
Once your holes are drilled you can use the two supplied M3
screws to secure the SXRC Control Head to your mounting
surface. If the supplied screws are not long enough to reach the
SXRC Control Head you can supply your own M3 screws of the
required length to secure the SXRC.
NOTE!!! Whether using the supplied M3 screws from the SXRC
kit or your own, the screws can not enter into the SXRC more
than 5/16” (4 mm). If you attempt to insert the screw any deeper
than this into the SXRC Control Head you will run the risk of
damaging the unit.
Route the SXRC Control Head cable to your SXRC Interface
Box location.Your SXRC Control Head is now mounted and you
can move on to the wiring section of this manual.
Mounting Surface
NO MORE THAN 5/16" (4 mm)
Mounting Surface
Mounting Surface