Sx amplifiers sxrc – Fortinet 2 SXRC User Manual

Page 13

SXRC Remote Control

Installa

tion

Now insert the removable power plug into the SXRC Interface

Box.

You should have something resembling this picture at this

point. The Control Head plugged in and the power plug wired
correctly and plugged in.

FROM AMP

+ 12V REM

GND

TO SXRC

Interface Box

RJ45 Communication

Network Jack

Power, Ground

Remote Jack

+12 Volt

Ground

Remote

HyperFlex

Fuse

Control Head

HOME

ENT

ESC

SYS

MEM-1

GAIN EQ LPF HPF

KOMP

AMP1

LOCK

MEM-2

MEM-3

MEM-4

PHASE

MUTE

AMP2

LEFT

RIGHT

k i c k e r

+12 Volt

Ground

Remote

HyperFlex

FROM AMP

+ 12V REM

GND

TO SXRC

Interface Box

Fuse

NOTE!!!

There are 8 pins in each RJ45 jack used on the SXRC

Interface Box and on SX Series amplifiers. We only use 3 of
these pins for the Digital Communications Network: Pins #2, #7
and #8.

If pins #2, #7 or #8 are bent or damaged, you will not be able

to establish reliable communications on the SXRC Digital
Communications Network.

A common issue is if your SX Series amplifier has been used

with the Remote Bass Level Controller prior to being used with
the SXRC. Some cables that came with the SX Series amplifiers
for use with the Remote Bass level Controller will bend pins #1
and #8 down too far causing poor contact with the SXRC
Communications Network Cable. To fix this simply take a small
screwdriver or paper-clip and pull these pins back up into place.

Check all the RJ45 jacks on your amplifiers to insure the pins

are up and in place before plugging in any of your SXRC
Communications Network Cables.

12345678

SX Amplifiers

SXRC