Furuno NAVpilot NAVpilot-500 - Manual (Page 65)

6. MAINTENANCE & TROUBLESHOOTING
6-6
SYSTEM DATA
You can confirm the current equipment and drive system status.
1. Press the [MENU] key to show the mode menu.
2. Rotate the [ENTER] knob to select “SYSTEM DATA”.
3. Press the [ENTER] knob to show the system data screen.
INPUT VOLTAGE: 24.4 V
CONTROLLER ID: 1
DRIVE TYPE: SOLENOID
BYPASS/CLUTCH: NON
CONTROLLER TEMP: 43.4 F
FET TEMP.: 24.6 F
MOTOR DRIVE CUR.: 0.0 A
BYPASS/CLUTCH CUR.: 0.0 A
SYSTEM DATA
System data screen
6.4 Clearing Memories
Memories can be cleared to restore to default settings.
1. Press the [MENU] key to show the menu.
2. Rotate the [ENTER] knob to select “SYSTEM SETUP”.
3. Press the [ENTER] knob to show the System setup menu.
4. Rotate the [ENTER] knob to select MEMORY CLEAR at the bottom of the
second page.
5. Press the [ENTER] knob to show the memory clear options window.
DISPLAY CLEAR
ALL CLEAR
Memory clear options window
6. Rotate the [ENTER] knob to select ALL CLEAR or DISPLAY CLEAR as
appropriate.
ALL CLEAR: Restores all default settings.
DISPLAY CLEAR: Restores settings other than the installation settings, ship’s
moving feature and compensation for the sensor connected.
Note: If you select ALL CLEAR, the all memories and settings stored in the
equipment are erased.
7. Press the [ENTER] knob. You are asked if you are sure to clear memory
selected
8. Press the [ENTER] knob to clear, or press any key to escape.
When the [ENTER] knob is pressed, the equipment restarts automatically.