Furuno NAVpilot NAVpilot-500 - Manual (Page 58)

5. ALARMS
5-7
5.1.10 Clearing the trip distance
You can reset the trip distance to zero as follows.
1. Rotate the [ENTER] knob to select CLEAR TRIP LOG from the ALARM
menu.
2. Press the [ENTER] knob to show the log trip clear options window.
YES
NO
Log trip clear options window
3. Rotate the [ENTER] knob to select “YES” to reset the trip distance.
4. Press the [ENTER] knob.
5.2 Alarm Information
When an alarm setting has violated, the buzzer sounds and the speaker icon
appears. Press any key to silence alarm. You can see which alarm has been
violated on the ALARM menu. In the example below the arrival alarm has been
violated.
1. Press the [MENU] key to show the mode menu.
2. Rotate the [ENTER] knob to select ALARM MENU, and then press the
[ENTER] knob to show the ALARM menu.
AUDIO ALARM:
ALARM INTERVAL: SHORT
WATCH ALARM: OFF
DEVIATION ALARM: 30
XTE ALARM: OFF
NEXT PAGE
INTERNAL BUZZER
ALARM MESSAGE 1 NOT CONFIRMED
DEVIATION ALARM
Alarm information window
CONTINUE
Alarm menu (page 1)
3. Press the [TURN] key to acknowledge the alarm (and silence the buzzer if it
was not done with any key). The message “NOT CONFIRMED” changes to
“CONFIRMED.” This is erased when the alarm is eliminated. When two or
more alarms have been violated, "CONTINUE" and left and (or) right arrows
appear at the bottom of the ALARM menu. The arrows indicate which key to
press to display next alarm message. Press the [STBD] key to show
messages of highest priority; the [PORT] key to display messages of lower
priority.
4. Press the [MENU] key twice to finish.