FUJITSU fi-4990C - Manual (Page 83)

6-31
1. In <> initial screen, press
ENTER .
The <> menu screen
(Paper Length Check) appears.
2. Press repeatedly until “Picking Speed”
appears in the lower line of the menu screen.
3. Press
ENTER
.
The option select screen appears with the
current setting Fast blinking (blinking indi-
cates “changeable”).
4. Press or .
The displayed option changes (Fast to Slow).
5. Press ENTER to save the change.
The LCD returns to the <>
menu screen (Picking Speed).
6. Press
CANCEL
two times.
The LCD returns to the Ready screen.
<>
<>
Paper Length Check
<>
Picking Speed
Picking Speed
Fast
Picking Speed
Slow
<>
Picking Speed
Ready
The following is an example of operation when you use this function.
TP_IF baud rate
This function sets the baud rate (signaling speed) according to the baud rate of the third party inter-
face (TP_IF).
NOTE
You cannot use this function when the setup mode is brought by pressing MENU in the Ready
status.
Remarks
Unit: baud
LCD display
TP_IF Baud Rate
Options
2400, 4800, 9600, 19200 (Default: 9600)
14C6.P65 01.2.17, 5:46 PM 31