FujiFilm 3000 - Manual (Page 32)

30
TROUBLESHOOTING
If a problem occurs during the printing process, follow the remedies outlined below. If the
printer fails to function properly even after corrective action has been taken, contact the
dealer from whom you purchased your PosterPrinter 3000.
Problem Description and Remedies
No.
1
2
3
4
5
6
Check that the power cord has been plugged in properly.
• Clean the platen glass in the scanner unit.
• If vertical lines appear on the poster at the thermal head
intervals, perform the 'Vertical line adjustment' in function
mode.
• Clean the thermal heads.
(It is recommended that you clean the thermal heads when
using Thermal Transfer Paper and HDP Paper after using
Direct Thermal Paper. )
• If horizontal lines appear on the poster at roughly
0.8inches/20mm intervals, perform the 'Horizontal line
adjustment' in function mode.
• Check to see if the surface of the platen rubber is clean.
• Clean the surface of the platen rubber if needed.
• The printer cover is not closed properly.
Open the cover and reclose it firmly holding both ends.
• Check to ensure that the scanner cover and printer cover
are closed properly.
• Check to ensure that the paper roll has been installed properly.
• Clean the document feed rollers and/or paper feed rollers if
necessary.
• Check to ensure that the paper roll has been installed
properly.
• Check to ensure that the original has been placed face
down in the document bay.
• Set the contrast level to darker position.
• If the images or text on the original are too light, change to
a better copy of the original where possible.
• Check that the type of paper indicated on the message
display matches the type actually being used.
• Paper rolls may expand or shrink with changes in humidity
levels. Loosen the adjustment knob and move the left
paper bracket until the paper can be installed properly, or
install a new paper roll.
The printer does not work even though
the power switch has been turned on.
1) If vertical lines appear
on the poster.
2) If horizontal lines appear
on the poster.
3) If spots appear periodically
on the poster.
4) If the left side of the
printed image does not
appear.
The printed image is not aligned
properly.
The printed image does not appear
(blank output).
Printed images or text are excessively
thin or light.
The paper roll loaded is too tight or too
loose in the brackets.
P3
P33
P22
P32
P22
P32
P12
P12
P15
P12
P32
P33
P12
P15
P11
P11
P13
Description Remedy Ref.
Spots or lines appear on the printed poster.
9