FujiFilm 3000 - Manual (Page 14)

12
printer cover
open/close knob paper bracket (left)
paper bracket (right)
After releasing the open/close knob,
lift the printer cover gently until it
comes to rest in the open position.
INSTALLING PAPER
BEFORE PRINTING
3
Set the left paper bracket into position
according to the width of the paper to
be used.
printing side of paper (inside)
end cap
triangular mark
paper
guide mark
guide mark
Insert the end caps into both ends of
the paper roll.
Note that the triangular marks on the end caps are designed as
guides to show the amount of paper remaining on the roll.
Install the paper in the printer.
Install the paper roll so that the end of the paper runs out
from the bottom of the roll.
The paper remaining from the tip of the mark:
direct thermal paper: approximately 19.7ft/6m.
thermal transfer paper and HDP paper: approximately 26.2ft/8 m.
about
8"/200mm
paper
guide mark guide mark
If the paper is installed incorrectly, the poster may be printed at
an angle, or wrinkles may occur.
Align the paper with the guide marks.
When installing paper, pull the end of the roll out
approximately 8”/200mm, so that any slack is removed from
the paper. Align the paper with the guide marks on either
side.
click
click
If the printer is turned on, about 1.8”/45mm of paper will
automatically advance.
Hold the ends of the printer cover with
both hands and gently push the cover
down until locked in place.
Check that both ends are closed properly.
Refer to ‘Setting the left paper bracket’,p13.