FujiFilm 3000 - Manual (Page 26)

24
6
REMAINING PAPER MODE
Use the remaining paper mode to check how much paper remains on the roll in use.
In addition, if the paper roll is changed midway, the amount of remaining paper can be
printed on the roll for future reference.
Setting the Amount of Remaining Paper
Press the clear key for at least 3
seconds. The ‘RESIDUAL’ screen in remaining
paper mode will be displayed. Press
the start/stop key.
press for at least
3 seconds
Press the start/stop key for at least 3
seconds to revert to the ‘RESIDUAL’
screen in remaining paper mode.
press for at least
3 seconds
press for at least
3 seconds
Press the clear key for at least 3
seconds to revert to the original
message display.
The ‘INPUT RESIDUAL’ screen will be
displayed. Input the amount of
remaining paper.
For new rolls of direct thermal paper:
Each time the paper type key is pressed, the display shows
‘85’ or ‘98’. Input 98 feet.
For new rolls of thermal transfer paper or HDP paper:
Each time the paper type key is pressed, the display shows
‘85’ or ‘98’. Input 85 feet.
For rolls of paper that are already used:
Input the amount using the mode key (-) and contrast key (+).
Each time either key is pressed, the number advances 1ft.
further in that direction.
Press the start/stop key to store the
input data.
'H' (hold) will be displayed.