FujiFilm 3000 - Manual (Page 15)

13
Move the cutter unit
in a sliding motion
towards the right
to cut the paper.
Using force on the paper cutter has no advantageous effect.
Pressing down lightly is sufficient. The cutter may be used from
either direction.
Caution
When the printer cover is open, pressing
down on the paper cutter lever will cause the
blade to protrude.
Exercise due care to avoid cutting yourself.
PROPER USE OF THE CUTTER
Lightly press down on the cutter lever
while holding the edge of the paper
underneath it.
end cap
adjustment knob
thermal paper
left paper bracket
Adjusting the left paper bracket
If the paper (with end caps attached) does
not fit properly in the paper bracket, loosen
the adjustment knob and move the paper
bracket so that the paper can be installed
properly.
correct set position
Setting the left paper bracket
3
adjustment knob
left paper bracket
paper size label
A
1
2
Setting the bracket in the printer
Install part A of the bracket according to
the paper size label marks, in order 1 2
Move the cutter in a downward horizontal sliding
motion while holding the paper out from the printer.
Cut the paper.