FORD Vehicle - Manual (Page 25)

22
* [SR09800(BEF )05/95] RWARNING
Failure to follow these instructions will
affect the performance of the safety belts
and increase the risk of personal injury.
% * [SR09900(BEF )05/95]
Safety Belt Maintenance
[SR10000(BEF )02/95] Check your safety belt system periodically to
make sure that it works properly and isn’t
damaged. If the webbing shows any wear, nicks
or cuts, have it examined by a qualified
technician to determine if replacement is
necessary. Always have your safety belt system
checked after a collision by a qualified
technician.
* [SR10200(BEF )05/95] All safety belt assemblies, including retractors,
buckles, front seat belt buckle support assemblies
(slide bar) (if so equipped), child safety seat
tether bracket assemblies (if so equipped), and
attaching hardware, should be inspected after
any collision. Ford recommends that all safety
belt assemblies used in vehicles involved in a
collision be replaced. However, if the collision
was minor and a qualified technician finds that
the belts do not show damage and continue to
operate properly, they do not need to be
replaced. Safety belt assemblies not in use
during a collision should also be inspected and
replaced if either damage or improper operation
is noted.
% * [SR10210(BEF )05/95] Cleaning the Safety Belts
* [SR10220(BEF )05/95] Clean the safety belts with any mild soap
solution that is recommended for cleaning
upholstery or carpets. Do not bleach or dye the
belt webbing because this may weaken it.
File:ltsrf.ex
Update:Thu May 9 15:26:26 1996