Printing a sample card, Reviewing the file listing, Entering the print only command – FARGO electronic M30e User Manual
Page 12: Entering the print with mag encoding command
Fargo M30e CUPS Driver User Guide (Rev. 1.0.3)
12
Reviewing the File Listing
/usr/share/cups/model/M30e.ppd
PPD File for the M30e Card Printer
/usr/lib/cups/filter/rastertofargoM30e
Raster Filter for the M30e Card Printer
/usr/share/fargo/M30e/M30eTst.prn
Test Print file
/usr/ share/fargo/M30e /RibbonCal.prn
Ribbon Sensor Calibration File
/usr/ share/fargo/M30e/CleanPrinter.prn
Clean Printer File
Printing a Sample Card
Entering the Print Only Command
Run the following command:
# lp
–d [PrintQueueName] [filename]
Entering the Print with Mag Encoding Command
Run the following command:
# lp
–d [PrintQueueName] –o “Magtrack1=%25MAGTEST1%3F
Magtrack2=%3B1234567890%3F Magtrack3=%3B1234567890%3F” [filename]