Follett C/E12CI400A - Manual (Page 30)

top cover
Panel removal
screw
front cover
Splash panel: Remove 2 screws. Pull out bottom
of panel to allow top to slide out from under
hopper support lip.
LH side
screw
back panel
louver
RH side panel
screw
panel
panel
screw
splash panel
hopper support lip
(a) Remove 4 fan mounting screws
and 3 drain tubes from bracket.
(b) Rotate fan mounting bracket
toward back of unit and pull
fan assembly toward front of
unit.
(c) As fan assembly is being pulled
toward front, rotate assembly
clockwise as shown above.
Fan removal
Side panels: Remove screw located on lower rear side.
Pull side panel toward front of unit and out of
back panel. Note: Before removing right hand side,
remove side louver panel by lifting up and pulling
forward on panel.
Front cover: Remove 2 screws. Lift cover up and
forward to unhook from keyhole slots and clear tabs on
bottom of cover. Top cover: Lift cover up and off Velcro strips.
mounting
screws
drain tube
bracket
30