Follett C/E12CI400A - Manual (Page 28)

Disassembly and replacement instructions
Dispense chute removal
1. Remove top cover (see page 30).
2. Remove stainless front cover (see page 30)
3. Slide plastic dispense chute cover up and out to
remove.
4. Remove four (4) push fasteners holding dispense tube
in place and remove tube.
Dispense wheel and drive bar removal
1. Remove all ice from storage area of dispenser.
2. Remove center thumbscrew, locking plate, two
wingnuts and backing plate from front of storage
hopper (see drawing at right).
3. Remove stud assembly, agitator, spacer, baffle, wheel
and drive bar in this sequence.
Wheelmotor removal
1. Remove dispense wheel and drive bar (see above).
2. Remove four (4) hopper/support plate mounting screws
and washers (Fig. 11.1).
3. Move hopper assembly 1/2" (13mm) to left.
4. Remove four (4) dispenser motor bracket mounting
screws and washers (Fig. 11.2).
5. Short shaft motors only: loosen only two (2) lower
screws on drive coupling and remove from motor shaft
(Fig. 11.3).
6. Remove four (4) screws holding motor to mounting
bracket.
28
stud assembly
agitator
dispense wheel
drive bar
baffle
backing plate
wingnut
1 – mounting
screw &
washer
hopper/
support
plate
assembly
drive coupling
assembly
shield
dispense motor (short shaft)
2 – dispense motor mounting screws
MOVE HOPPER ASSEMBLY 1/2"
(13mm) TO LEFT
mounting
bracket
3
Fig. 11
dispense motor (long shaft, current)