FUJITSU SPARC ENTERPRISE T5120 - Manual (Page 7)

Contents vii
prtdiag -v Voltage Indicators Section Has Non-Voltage Indicators (CR
6587380) 19
prtdiag -v Slow To Respond on 1U (CR 6588550) 19
Control-C from prtdiag, Blank Environmental Data Fields When Run
Again (CR 6552999) 19
Firmware and General Software Issues 20
IPMI Chassis Power Cycle Does Not Always Work (CR 6602913) 20
No keyboard support found; Can’t open USB keyboard
package (CR 6601900) 20
Ierrs Generated When 100Mb/Full With Forced Speed/Duplex is Set in
e1000g.conf (CR 6555486) 20
ereport.fm.ferg.invalid DMU Core and Block Error Status(0) No
bits Set (CR 6598381) 21
USB Device Causes Panic on DMA to Address 0 (CR 6555956) 22
VBSC Did Not Detect Memory One Time: ERROR:
MB/CMP0/BR3/CH0/D0 must be populated (CR 6604305) 22
rm-io Followed by Multiple set-vcpu Operations Could Cause HV
Abort or ldmd Core Dump (CR 6597761) 23
cryptotest Intermittent SUNW_RANDOM Generate Failure (CR
6572985) 23
modunload While the nxge Port is Running, Could Cause a System Panic
(CR 6551509) 23
When Either NIU Port in the N2 CPU is Disabled the Corresponding XAUI
is Configured (CR 6599334) 25
Booting Solaris OS From External USB DVD-ROM Drive Could Cause
Panic and Fail to Boot (CR 6588452) 25
SPARC Enterprise T52x0 Hangs When Trying to Boot With Infiniband
HBA Card Installed (CR 6578410) 25
mpt Handles SMART Event From the LSI Firmware (CR 6574127) 26
Setting Properties for N2/NIU nxge Devices Could Fail (CR 6561389) 26
ldc_skt and ds Might Not Handle LDC Resets Properly (CR 6583567)
27
ID 216524 daemon.error Registration With DMI Failed
err = 831 (CR 6237994) 28