FUJITSU SPARC ENTERPRISE T5120 - Manual (Page 54)

44 SPARC Enterprise T5120 and T5220 Servers Product Notes • October 2007
3. Enter the break command as follows.
Log back into the Solaris host with the console command.
Refer to the Integrated Lights Out Manager 2.0 User’s Guide and the Integrated Lights
Out Manager (ILOM) Supplement for SPARC Enterprise T5120 and T5220 Servers for
details on how to use the break command from the SP CLIs.
Write to Virtual Blade Server Control (VBSC) Illegal Seek (CR
6582340)
When connected to the virtual-console and the escape character sequence is input to
enter the SP CLI, two error messages might get printed before reaching the CLI
prompt:
This situation occurs when there is a lot of output through the console, and could
indicate that the console is in use when it is not.
Workaround: If you are refused write access the next time you initiate a connection
to the host with the console command, enter the console -f (the force option) to
get read and write access.
DIMM FRUs Must Be Presented With the IPMI Interface (CR
6591367)
You cannot obtain the system DIMM FRU information with the ipmitool utility.
Obtain the DIMM FRU information with the SP ALOM CMT compatibility CLI (with
the showfru command) or the SP ILOM CLI (with the show fru-name command) on
the SP. Refer to the Integrated Lights Out Manager 2.0 User’s Guide and the Integrated
Lights Out Manager (ILOM) Supplement for SPARC Enterprise T5120 and T5220 Servers
for details on the preceding commands to obtain FRU information on the SP.
-> set /HOST send_break_action=break
->
-> start /SP/console
Are you sure you want to start /SP/console (y/n)? y
Serial console started. To stop, type #.
c)ontinue, s)ync, r)eboot, h)alt?
read: Connection reset by peer
Write to vbsc: Illegal seek
sc>