Created (cr 6592238), Raidctl -l, Available to ldoms manager (cr 6597815) – FUJITSU SPARC ENTERPRISE T5120 User Manual

Page 40

SPARC Enterprise T5120 and T5220 Servers Product Notes • October 2007

Unable to Remove RAID 1 Volume After RAID 1 and RAID 0
Volumes Are Created (CR 6592238)

When two volumes are created over an mpt controller, the raidctl utility is unable
to delete one of the RAID volumes and cannot list the correct disk information. The
following is the error message:

raidctl -l

Continuously Outputs Disk: 0.0.0 (CR 6589612)

In this case, if you run raidctl -l, you get the following output:

You must use the Control C keyboard sequence to stop the output.

IO-Domain-Reset: ERROR: Last Trap: Watchdog Reset (CR
6593547)

You might see the following error in either the I/O or the Control domain when
attempting to boot and the auto-boot sequence will be aborted:

Workaround: Type boot at the OpenBoot OK prompt to proceed.

XAUI and CPU Resources Added After Initial LDoms Setup
Are Not Available to LDoms Manager (CR 6597815)

When you add CPU or XAUI resources to a server configured to use logical
domains, you must revert to the factory default configuration to allow the LDoms
Manager software to allocate those resources to guest domains.

# raidctl -l

Device record is invalid.

# raidctl -l

Controller: 1

Volume:c1t0d0

Volume:c1t2d0

Disk: 0.0.0

...

"ERROR: Last Trap: Watchdog Reset".