FieldServer Data Aire (DAP) FS-8704-49 - Manual (Page 8)

FS-8700-49_Data_Aire_DAP Page 8 of 48
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.FieldServer.com
Tel: (408) 262-2299 Fax: (408) 262-2269 Toll_Free: 888-509-1970 email: [email protected]
4.2. Client Side Connection Descriptions
Connections
Column Title
Function Legal Values
Port
This is the FieldServer port
connected to the DART’s RS-
232 port. P1-P8, R1-R2 1
(P1-P8) requires 232/485
converter.
Secondary_Port*
The return loop from the DAP
devices is connected to this
port. (Loop connected to Tx+
& Tx- terminals.
P1-P8, R1-R2 1
(R1-R2) requires 232/485
converter.
Baud* Specify baud rate
2400/9600 2 (Vendor
Limitation)
Parity* Specify parity None
Data_Bits* Specify data bits 8
Stop_Bits* Specify stop bits 1
Protocol
Specify protocol used. Either
keyword may be used.
DAP, Daire
Handshaking*
Specify hardware
handshaking
None
Poll Delay* Time between internal polls 0-32000s, 1s
Example
// Client Side Connections
Connections
Port, Secondary Port, Protocol, Baud, Parity, Data_Bits, Stop_Bits, Poll_Delay
R1,
R2, DAP, 2400, None, 8, 1, 0.100s
1
Not all ports shown are necessarily supported by the hardware. Consult the appropriate Instruction
manual for details of the ports available on specific hardware.
2
DAP V9.5 or later supports 9600
Use this port identifier in the client side node
configuration described in Section 4.3.