Fortinet FortiGate 5050 User Manual
Page 15
Power connection and configuration
FortiGate-5050 Chassis Guide
01-30000-87211-20090106
15
To connect the FortiGate-5050 chassis to data center ground
You need the following tools and equipment to connect the FortiGate-5050 chassis to
ground:
• A number 2 Phillips screwdriver.
• An electrostatic discharge (ESD) preventive wrist or ankle strap with connection cord.
• One green AWG-6 stranded wire with terminal lugs attached.
Figure 7: Connecting a FortiGate-5050 chassis to data center ground
1 Attach the ESD wrist strap to your wrist and to an ESD socket or to a bare metal
surface on the chassis or frame.
2 Connect the green ground wire from the data center ground to the ground connector on
the FortiGate-5050 chassis (see
).
3 Secure the ground wire to the chassis.
4 Optionally label the wire GND.
Connecting the FortiGate-5050 chassis to AC power using the
FortiGate-5053 power converter tray
If data center DC power is not available, you can use the FortiGate-5053 power converter
tray with FortiGate-5020/5050 power supplies (shown in
) to convert AC power to
DC power. The FortiGate-5053 power converter tray and the power supplies are not
supplied with the FortiGate-5050 chassis and must be purchased separately. (FortiGate-
5020/5050 power supplies are also used to provide power to a FortiGate-5020 chassis.)
This section contains the following information about the FortiGate-5050 chassis and the
FortiGate-5053 power converter tray:
•
FortiGate-5053 power converter tray front and back panel
•
•
Connecting a FortiGate-5050 chassis to the FortiGate-5053 power converter tray
FortiGate-5053 power converter tray front and back panel
The front panel of the FortiGate-5053 power converter tray (shown in
) provides
access to the FortiGate-5020/5050 power supplies.
FortiGate-5050
Ground
connector
Data Center
ground
connector