Furuno GP-1600F - Manual (Page 44)

2 – 20
5) Operate the [Arrow] keys to select route waypoint which you
want to erase.
6) Press the [CLR] key.
7) Press the [MENU ESC] key several times to escape.
Note: To erase entire route, erase all waypoints.
2.17 Entering Marks
You can inscribe marks on the display to denote important loca-
tions; for example, buoy, fishing point, wreck. Further, marks can
be connected with lines to depict important areas such as a hot
fishing spot or danger area.
Enabling entry of marks
The [EVENT MOB] key enters marks. When the key is pressed a
mark, an event mark or MOB mark appears on the display depend-
ing on menu setting.
To enable entry of marks on the display, do the following:
1) Press the [MENU ESC] key.
2) Press the [0] key to select SYSTEM MENU.
3) Press the [2] key to select PLTR SETUP.
PLTR SETUP
NAVAID OWN LC DC ALL
SCALE SCALE RANGE
SMOOTHING 00 (00~15)
SPD AVERAG 00 min
BEARING TRUE
MAG
MAG CALIB AUTO MAN
06.9° W 00.0° E
EVNT METHOD
EVENT MARK
POSITION L/L LOP
DISP LC DC
Chain:Sec 7970:11-26
LOP CALIB +000.0
µ
s
+000.0
µ
s
:E/W
▼▲ :Cursor ESC:Esc
Figure 2-23 PLTR SETUP menu
4) Press the [▼] or [▲] key to select EVNT METHOD.
5) Press the [ s] key to select MARK.
6) Press the [MENU ESC] key.