FARGO electronic HDP700 - Manual (Page 37)

FARGO Electronics Inc.
HDP700 Series Card Printer 3-1
Section
3
Printer Adjustments
This Section covers the replacement of key components of the card printer. Be sure to reverse the
disassembly steps to reassemble the card printer.
Safety Messages
Procedures and instructions in this Section may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential safety issues is indicated by a
warning symbol (as shown below).
Refer to the following safety messages before performing an operation preceded by this symbol.
DANGER
Failure to follow these installation guidelines can result in death or serious injury. Always remove the power
cord prior to performing repair procedures, unless otherwise specified. Make sure only qualified personnel
perform these procedures.
Procedures and instructions in this Section may require special precautions to ensure the safety of the
personnel performing the operations. Information that raises potential electrostatic safety issues is indicated
by a warning symbol (as shown to the below).
Refer to the following safety messages before performing an operation preceded by this symbol.
CAUTION
This device is electrostatically sensitive. It may be damaged if exposed to static electricity discharges. Be sure
to observe all established electrostatic discharge (ESD) procedures while handling cables in or near the
Circuit Board and Printhead Assemblies. Always wear an appropriate personal grounding device, such as a
wrist strap with integral resistor, connected to an ESD ground to avoid potential damage.
IMPORTANT
Always remove the HDP Ribbon and Cards from the printer before making any repairs, unless otherwise
specified. Take jewelry off of fingers and hands and be sure to thoroughly cleanse hands to remove oil and
debris before working on the printer.