FARGO electronic HDP700 - Manual (Page 128)

FARGO Electronics Inc.
HDP700 Series Card Printer A-3
7.2 Print Test Image
Choose PRINT TEST IMAGE to select a preset test image. These images help to determine if the
printer is functioning properly. Scroll to the desired test image from the SELECT TEST IMAGE
options and press the SELECT.
Figure 7-5
Figure 7-6
Figure 7-7
Figure 7-8
Gray/Align YMCK for HDP710 Gray/Align YMC/K for
HDP720
This card is used to determine image placement and confirm
that the printer is working properly. The image consists of
sixteen grayscale boxes and alignment arrows. Refer to Section
7.3 for adjusting image placement. Although the boxes are gray,
they are composed from a composite of YMC color panels.
Color/Resin YMCK
This card is used to determine image placement and confirm
that image colors are properly reproduced and the resin panel is
printing properly. Image consists of twelve spot colors, YMC and
RGB, as well as gray density bars and thin resin lines.
Color Bars YMC
This card is used to confirm that image colors are properly
reproduced. Image consists of sixteen graduated steps of RGB
and YMCK. This print will provide maximum image size, giving
complete card coverage on a CR-80 sized card.
Card Count
This card is used to view counts for Card Count (CC), Pass
Count (PC),
and Transfer Count (TC).
Card Count is the total number of cards the printer has
produced. Pass Count is the total number of print passes made
by the Printhead; a pass is measured each time a single ribbon
panel is printed or passes beneath the Printhead. Transfer
Count
is the total number of times the printer transfers an
image to a card.