FARGO electronic HDP700 User Manual

Page 102

FARGO Electronics Inc.

4-44

HDP700 Series Card Printer

8. Slide the card feed gear off the roller shaft.

9. Use the standard screwdriver to remove the retaining clip from the shaft.

10. Slide the brass bushing off the roller shaft.

11. Depress the interior bushing on the front side of the flipper table against the spring.

12. Push the flipper table towards the back of the printer.

13. Push the side of the flipper table that is towards the front of the printer downward to release

it from the drive roller shaft.

14. Once the Flipper Table is clear of the roller shaft, pull it towards the front of the printer to

release it from the alignment posts.

15. Remove the two screws (F000169) that secure the Sensor Assembly.

16. Disconnect the cable connector.

4.8.12 Card Feed Sensor
(D840625)

Refer To Drawing 840156

Tools Needed

Phillips-head Screwdriver, Torx T-10 Screwdriver

1. Turn off the printer and unplug the power cord from the printer.

2. Open the Front Access Door.

3. Detach the LCD Interface Cable (D840517) from the HD7XXX User Interface Board

Assembly (140403).

4. Remove the five screws from the base of the Card Input Hopper Cover and remove the other

four screws from inside the print station.

5. Lift the Card Input Hopper Cover off of the printer.

6. Remove the Cleaning Roller Assembly to allow access to the sensor assembly.

7. Remove the two screws (F000191) that secure the sensor assembly.

8. Disconnect the cable connector.