Henny Penny SMART COMBI FM05-061-A - Manual (Page 50)

4. Set the target core temperature if desired.
5. Set the chamber humidity.
6. Load the unit.
7. Press S t a r t / S t o p ( 8 ) .
The multi-function display (4) shows:
- the set cooking temperature
- the set cooking time
- the target core temperature
4.9.5 Start Delta-T cooking
Requirements Unit is switched on
NOTICE
Since the core temperature of the food being cooked is needed, you
must use the core temperature sensor with Delta-T cooking.
1. Press the right s e l e c t bu t t o n ( 6 ) .
The multi-function display (4) shows “
ΔT cooking” and “LT cooking”.
2.
Use C o m b i D i a l ( 9 ) to select “
ΔT cooking”.
NOTICE
Delta-T cooking is possible with the “Steaming”, “Combisteaming” and
“Convection” cooking modes.
3. Press cooking mode button.
The key's LEDs are lit.
The multi-function display (4) shows the cooking mode, Delta-T value
and target core temperature.
4. Use C o m b i D i a l ( 9 ) to set the Delta-T value.
5. Set the target core temperature with C o m b i D i a l ( 9 ) .
6. Press S t a r t / S t o p ( 8 ) to start the cooking program.
The multi-function display (4) shows the current chamber temperature
and the target core temperature.
4.9.6 Starting low temperature cooking
Low temperature cooking without core temperature measurement
Global Foodservice Solutions
Operating manual 50
SmartCombi ™
Operation