Heartland Toledo XT - Manual (Page 30)

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
30
Installation Safety
Instructions
Warning!
Improper installation, adjustment, alteration, service
or maintenance can cause injury or property damage.
Refer to this manual. For assistance or additional
information, consult a qualified installer, service
agency, manufacturer (dealer) or the gas supplier.
Never reuse old flexible connectors. The use of old
flexible connectors can cause gas leaks and personal
injury. Always use NEW flexible connectors when
installing a gas appliance.
Important
Remove all packing material and literature from oven
before connecting gas and electrical supply to range.
• Have your range installed by a qualified installer.
• Your range must be electrically grounded in
accordance with local codes or, in the absence
of local codes, in accordance with the National
Electrical Code (ANSI/NFPA 70, latest edition).
• Before installing your range on linoleum or any
other synthetic floor covering, make sure the floor
covering can withstand 180°F without shrinking,
warping or discoloring. Do not install the range
over carpeting unless a sheet of 1/4’’ thick plywood
or similar insulator is placed between the range
and carpeting.
• Make sure the wall coverings around the range
can withstand heat generated by the range up to
200°F.
• Avoid placing cabinets above the range. There
must be a gap of at least 30’’ (76cm) between
the top of the range and any combustible surface
above it.
If a ventilating hood is installed above the range
follow the installation instructions supplied with the
hood.
Caution
Items of interest to children should not be stored
above a range - children climbing on the range to
reach items could be seriously injured.
Converting to LP Gas
This appliance is supplied set for Natural gas.
A conversion kit for Propane gas is supplied with the
range.
If the appliance is to be converted this must be
done before installation. The conversion must be
performed by a qualified LP gas installer. See the
Conversion section at the back of this installation
manual for more details.