Bolt VX-760C Wireless TTL Flash for Cameras User Manual
Page 47

|
47
Troubleshooting
|
47
Problem
Solution
The flash is set up as a wireless
slave, but the light is not
noticeable in the picture.
• Make sure that the master flash is within the transmission range, and
that the wireless sensor on the slave is pointing toward the master
flash. Remove any obstructions in the line of sight between the two.
(Page 45)
• The ambient light may be too high. (Page 45)
The edges of the images look
dark.
• Make sure that the flash zoom setting corresponds to the focal length
of your lens. (Page 27)
• Your lens is wider than 24mm. Use the built-in wide-angle diffuser.
(Page 30)
The bottom of the images look
dark.
• To fully illuminate your subject when shooting close-up photography,
tilt the flash down to the -7° position. (Page 32)
• Your camera’s shutter speed is higher than its max sync speed in
manual mode. Use a slower shutter. (Page 27)