Bolt VX-760C Wireless TTL Flash for Cameras - Manual (Page 37)

| 37 Using the Multi (Stroboscopic) Mode | 37
maximum number of flashes. When the desired stroboscopic count number appears on the LCD, press the
MODE button to select it.
3. Set the firing frequency by pressing the SUB button repeatedly until the stroboscopic frequency number
blinks. The frequency, measured in hertz (Hz), indicates the number of flashes per second. Use the left
and right navigation buttons to adjust the frequency, or the up and down navigation buttons for the
minimum and maximum frequencies. When the desired stroboscopic frequency number appears on the
LCD, press the MODE button to select it.
4. To determine the appropriate shutter speed, divide the stroboscopic count number (the number of flashes
per frame) by the stroboscopic frequency number (the frequency of the flash).
For example: If the number of flashes per frame is 10, and frequency of the flash is 5 Hz, then
10 flashes per frame
5 HZ
so the shutter speed should be 2 seconds or slower.
Note: See Stroboscopic Reference Chart on page 49 for the maximum number of flashes at any given power/
frequency combination.
,