Bolt VX-760C Wireless TTL Flash for Cameras User Manual

Page 39

Using Your VX-760C as a Wireless Master or Slave

Groups:

With the VX-760C’s wireless system, you can assign slave flash units to any one of three groups (A, B,

or C) and set the mode and power for each group.

Channels:

Master and slave flash units exchange data through channels. On the VX-760C, four channels (1, 2,

3, and 4) are available. You can use this option to prevent your slave units from being triggered by the master
unit of another photographer working with the same type of system nearby.

Setting the master mode:

To set the VX-760C flash unit to function as a TTL or manual master, follow these

steps:

1. Press the MODE button repeatedly to cycle through the flash modes until the TTL or manual mode

indicator appears on the LCD.

For TTL mode, use the left and right navigation buttons to adjust the flash compensation value,
and the up and down buttons to fine-tune.

In manual mode, use the left and right navigation buttons to set the power level, and the up and
down buttons to fine-tune.