Bolt VX-760C Wireless TTL Flash for Cameras - Manual (Page 43)

| 43 Using Wireless Multi (Stroboscopic) Mode | 43
To set your VX-760C as wireless stroboscopic master, follow these steps:
1. Turn the flash on and press the MODE button repeatedly to cycle through the flash modes until MULTI
appears on the LCD.
2. To set the VX-760C as the master, press and hold the SUB button until the wireless flash icon and the
group and channel settings appear on the LCD. The channel number appears with a C next to it and blinks
alternately with the stroboscopic count number.
3. Use the left and right navigation buttons to adjust the flash output.
4. Set the number of flashes by pressing the SUB button so the stroboscopic count number blinks. Use the
left and right navigation buttons to adjust the number of flashes, or the up and down navigation buttons
for the minimum and maximum number of flashes. When the desired stroboscopic count number appears
on the LCD, press the MODE button to select it.
5. Set the firing frequency by pressing the SUB button repeatedly until the stroboscopic frequency number
blinks. Use the left and right navigation buttons to adjust the frequency, or the up and down navigation
buttons for the minimum and maximum frequencies. When the desired stroboscopic frequency number
appears on the LCD, press the MODE button to select it.
6. Set the group by pressing the SUB button until the wireless flash icon and the group and channel settings
blink. Use the left and right navigation buttons to select ALL, AB, or ABC, and press the MODE button to